Mazda 3 Workshop Manual - Driveline Axle

Online PDF Mazda 3 Workshop Manual - Driveline Axle

Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. 
Tightening torque 
88.2-117.6 N·m {9.00-11.99 kgf·m, 65.06-86.73 ft·lbf}
Connector Disconnection
1. Disconnect the negative battery cable before performing any work that requires handling of connectors. (See BATTERY REMOVAL/INSTALLATION [Z6].) (See BATTERY REMOVAL/INSTALLATION [LF].)
Suspension Links Removal/Installation
1. For the joint sections with rubber bushings, raise the vehicle using a lift, and then temporarily tighten the installation bolts and nuts. Lower the vehicle to the ground and tighten them completely with the specified torque.

Table Of Contents

  1. Mazda 3 Workshop Manual - DRIVELINE/AXLE
  2. GENERAL PROCEDURES (FRONT AND REAR AXLES)
  3. Wheel and Tire Installation
  4. Connector Disconnection
  5. Suspension Links Removal/Installation
  6. FRONT AXLE LOCATION INDEX
  7. WHEEL HUB, STEERING KNUCKLE INSPECTION
  8. Wheel Bearing Excessive Play Inspection
  9. WHEEL HUB, STEERING KNUCKLE REMOVAL/INSTALLATION
  10. Brake Caliper Removal Note
  11. Wheel Hub, Steering Knuckle Component Removal Note
  12. Wheel Hub Component Removal Note
  13. Wheel Hub Component Installation Note
  14. Lockbolt Installation Note
  15. REAR AXLE LOCATION INDE
  16. WHEEL HUB COMPONENT INSPECTIO
  17. Wheel Bearing Excessive Play Inspection
  18. WHEEL HUB COMPONENT REMOVAL/INSTALLATION
  19. Brake Caliper Component Removal Note 
  20. DRIVE SHAFT LOCATION INDEX 
  21. JOINT SHAFT INSPECTIO 
  22. JOINT SHAFT REMOVAL/INSTALLATION 
  23. Joint Shaft Removal Not 
  24. Clip Installation Note 
  25. JOINT SHAFT DISASSEMBLY/ASSEMBLY 
  26. Joint Shaft Disassembly Note 
  27. Bearing Disassembly Note 
  28. Dust Seal (RH) Assembly Note 
Online PDF Mazda 3 Workshop Manual - Driveline Axle

Download Mazda 3 Workshop Manual - Driveline Axle


Related Manuals

Popular Manuals