Mazda 3 Workshop Manual - Suspension

Online PDF Mazda 3 Workshop Manual - Suspension

Caution 
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor wiring harness connector (axle side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle. 

1. Remove in the order indicated in the table. 
2. Install in the reverse order of removal. 
3. Verify the camber and the caster are within the specification. If they are not within the specification, align the piston rod nut with the center of the shock absorber and coil spring again. (See Shock Absorber and Coil Spring Installation Note.) 
4. Inspect the total toe-in and adjust it if necessary. (SeeFRONT WHEEL ALIGNMENT.) 

Mazda 3 Workshop Manual - Suspension For Free

(0) Comments

Leave A Response

Your email address will not be published with your comments.

CAPTCHA Image
Reload Image