KTM 690 Enduro R 2020 Owners Manual

Free pdf KTM 690 Enduro R 2020 Owners Manual

Tampering with the noise control system is prohibited. Federal law prohibits the following acts or the causing thereof:

  1. The removal or rendering inoperative by any person other than for purposes of servicing, repair, or replacement, of any device or element of design incorporated into any new vehicle for the purpose of noise control prior to its sale or delivery to the ultimate purchaser or while it is in use, or
  2. the use of the vehicle after such device or element of design has been removed or rendered inoperative by any person.

Among those acts presumed to constitute tampering are the acts listed below:

  1. Removal or puncturing of the main silencers, baffles, header pipes or any other components which conduct exhaust gases.
  2. Removal or puncturing of parts of the intake system.
  3. Lack of proper maintenance.
  4. Replacing moving parts of the vehicle, or parts of the exhaust system or intake system, with parts other than those specified by the manufacturer.

Only operate the vehicle when it is in perfect technical condition, in accordance with its intended use, and in a safe and environmentally compatible manner. An appropriate driver's license is needed to drive the vehicle on public roads. Have malfunctions that impair safety promptly eliminated by an authorized KTM workshop. Adhere to the information and warning labels on the vehicle.

Unless specified otherwise, the ignition must be turned off during all work (models with ignition lock, models with remote key) or the engine must be at a standstill (models without ignition lock or remote key). Special tools are necessary for certain tasks. The tools are not a component of the vehicle, but can be ordered using the number in parentheses. Example: bearing puller (15112017000)
During assembly, use new parts to replace parts which cannot be reused (e.g. self-locking screws and nuts, seals, sealing rings, O-rings, pins, and lock washers).

In the case of certain screws, a screw adhesive (e.g. Loctite®) is required. Observe the manufacturer's instructions. If thread locker (e.g., Precote®) has already been applied to a new part, do not apply any additional thread locker. After disassembly, clean the parts that are to be reused and check them for damage and wear. Change damaged or worn parts. After completing a repair or service work, check the operating safety of the vehicle.

If you use your motorcycle responsibly, you can ensure that problems and conflicts do not occur. To protect the future of the motorcycle sport, make sure that you use your motorcycle legally, display environmental consciousness, and respect the rights of others. When disposing of used oil, other operating and auxiliary fluids, and used components, comply with the laws and regulations of the respective country.

Free Download KTM 690 Enduro R:

  1. KTM 690 Enduro R 2020 EU (en) - 2020.pdf
  2. KTM 690 Enduro R 2020 EU (de) - 2020.pdf
  3. KTM 690 Enduro R 2020 EU (es) - 2020.pdf
  4. KTM 690 Enduro R 2020 US (fr) - 2020.pdf
  5. KTM 690 Enduro R 2020 EU (ja) - 2020.pdf
  6. KTM 690 Enduro R 2020 EU (pt) - 2020.pdf
  7. KTM 690 Enduro R 2020 US (en) - 2020.pdf
  8. KTM 690 Enduro R 2020 US (de) - 2020.pdf
  9. KTM 690 Enduro R 2020 US (es) - 2020.pdf

KTM 690 Enduro R 2020 Owners Manual For Free

(0) Comments

Leave A Response

Your email address will not be published with your comments.

CAPTCHA Image
Reload Image