2014 KTM 450, 500 EXC, XC-W Service Repair Manual

Online PDF 2014 KTM 450, 500 EXC, XC-W and 6 DAYS Service Repair Manual

Special tools are necessary for certain tasks. The tools are not contained in the vehicle but can be ordered under the number in parentheses. E.g.: bearing puller (15112017000)
During assembly, non-reusable parts (e.g. self-locking screws and nuts, seals and seal rings, 0-rings, pins, lock washers) must be replaced by new parts.
In some instances, a thread locker (e.g. Loctite®) is required. The manufacturer instructions for use must be followed.
After disassembly, clean the parts that are to be reused and check them for damage and wear. Change damaged or worn parts.
After you complete the repair or service work, check the operating safety of the vehicle.

2014 KTM 450, 500 EXC, XC-W Service Repair Manual For Free

(0) Comments

Leave A Response

Your email address will not be published with your comments.

Reload Image