Jaguar XF Workshop Manual 2006 - 2007

Online Pdf Jaguar XF Workshop Manual 2006 - 2007

Engine Wiring Harness - Vehicles With: Supercharger
Removal
1. Remove the cover and disconnect the battery ground cable. 2. Raise and support the vehicle. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle 
on safety stands.
3. Remove the intake air resonator. 4. Remove the engine control module (ECM). 5. Recover the A/C refrigerant. 6. Remove the fan cowl.
- Remove the 15 clips.
7. Release and disconnect the engine wiring harness electrical connector.
- Fully loosen the bolt.
8. Release the ground cable from the power distribution box bracket.
- Remove the nut.
9. Release the engine wiring harness from the engine compartment side wall.
- Release the grommet.

5. Refer to GTR section 211-04: Steering Column operation 57.60.01 and install the steering wheel.
6. Refer to GTR section 501-20B: Supplemental Restraint System operation 76.73.39 and install the Driver Air Bag Module from the steering wheel.
7. Raise the vehicle on a suitable lift.
8. Install the vehicle undertray.
9. Road test the vehicle to confirm the steering wheel alignment is within the +/- 3° tolerance, when driving straight ahead on a level surface, and that the vehicle steering alignment is correct.
NOTE:
Any other steering alignment repairs are to be carried out as a separate Warranty Claim. Vehicle geometry machine print outs from before and after any steering alignment adjustments are to be submitted with warranty claim.
10. If the steering wheel is straight and level, and the vehicle does not track correctly during the road test, perform the following: 
-Reset the front individual toe to specification relative to the rear axle thrust line while maintaining the straight steering wheel position (i.e. Four-wheel alignment). 
-Road test the vehicle to confirm the steering wheel alignment is within the +/- 3° tolerance when driving straight ahead on a level surface, and that the vehicle alignment is correct.
11. Raise an Electronic Product Quality Report (EPQR) with the following information: 
-Photographic evidence of the alignment error, where possible. 
-Details as to the extent of steering wheel misalignment that was corrected. 
-An indication of the degree of initial steering wheel misalignment by stating the degree that 
corresponds most accurately to the misalignments (6°, 12°, 18° or 24°) illustrated in Figure 

Jaguar XF Workshop Manual 2006 - 2007 For Free

(0) Comments

Leave A Response

Your email address will not be published with your comments.

CAPTCHA Image
Reload Image