HAIMA 7 Service Manual(MT)-R Suspension system

Online Pdf HAIMA 7 Service Manual(MT)-R Suspension system

General procedures  
Precautions to the suspension system  Removal/installation of wheels and tires  
1.  The tightening torque in the installation of wheels: 88-127N.m {9.0-13.0kgf.m, 65-94ft.lbf}.
Tightening of suspension system 
1. All parts with the rubber bushings in the suspension can be tightened only when the vehicle has been laid down and is free of load. 
No-load: fuel tank already filled up, engine coolant and lubricant already reached to the specified liquid level, spare tire jack and outfit placed at a specified locations. 
Connection or Cut-off of braking line 
Attention: The brake fluid is likely to damage the painted surface. If the brake fluid already got in touch with the painted surfaces, it should be immediately wiped up. 
1. Tighten the brake cone nut by use of the SST, confirm the tightening torque of adjusting brake cone nut to ensure the combination use of torque wrench and SST. 
2. Add the brake fluid, exhaust residual gas from the brake system if any of the braking lines is disconnected in the process and check if there is any leakage after the completion of operation. 
Removal/installation of power steering component
1.If any of the power steering oil lines is disconnected in the process, you should add ATF M-Ⅲ or Dexron II, exhaust residual oil from the oil lines and check if there is any leakage after the completion of operation.

Preliminary inspection of wheel alignment  
1. Check the tires inflation and adjust them to the recommended pressure 210kPa as required. 
2. Check the front bearing clearance and make the necessary correction as needed (Refer to M Check of Wheel Bearing Clearance). 
3. Check the radial run-outs of wheels and tires. 
4. Check whether there is any excessive looseness of the ball pin and steering linkages. 
5. Sway the bodywork to check the operation of shock absorber. 
Note: The vehicle must be of no-load and positioned on a level ground.  
No-load: fuel tank already filled up, engine coolant and lubricant already reached to the specified liquid level, spare tire jack and outfit placed at a specified locations. 
6.Measure the vertical height between the wheel center and fender edge, the difference in the measured values between the left and right sides cannot exceed 10 mm{0.39 in}. 

HAIMA 7 Service Manual(MT)-R Suspension system For Free

(0) Comments

Leave A Response

Your email address will not be published with your comments.

CAPTCHA Image
Reload Image