Audi C5 A6 Brake Systems

Online PDF Audi C5 A6 Brake Systems

Front brakes (FN-3), servicing
Note:
Install complete repair kit.
After replacing brake pads and before moving vehicle, depress brake pedal several times firmly to properly seat brake pads in their normal operating position.
When siphoning brake fluid, always use a bleeder bottle that is used exclusively for brake fluid. Brake fluid is poisonous. NEVER siphon brake fluid with your mouth!
Wheel bolt tightening torque: 120 Nm Check brake caliper for freedom of movement by sliding to side.

1 - Brake hose
Do not disconnect when removing 
brake pads 
2 - Protective cap
Remove 
3 - Guide pins, 25 Nm 4 - Brake line, 15 Nm
Install in brake caliper housing 
Attach to brake hose, counter hold on brake hose hex 
when attaching Make sure tabs are 
properly seated in retainer grooves

5 - Brake caliper housing
- Check that the brake calipers moves freely by moving it from side to side
6 - Ribbed bolt, tightening torques

CAUTION!

Observe different tightening torques.

M12 x 1.5 x 35, 130 Nm 
M14 x 1.5 x 35, 200 Nm 
Clean ribs if reusing 
7 - Brake carrier
Bolt to wheel bearing housing

Retaining spring must be pressed under brake carrier after it is inserted in both holes. If the spring is improperly installed, the brake caliper cannot adjust to compensate for wear on the outer brake pad. This will cause the brake pedal travel to increase.

Audi C5 A6 Brake Systems For Free

(0) Comments

Leave A Response

Your email address will not be published with your comments.

CAPTCHA Image
Reload Image