Lincoln MKT Owners Manual

Free Pdf Lincoln MKT Owners Manual

Windows and Mirrors. The image of the approaching vehicle is small and near the inboard edge of the main mirror when it is at a distance. The image becomes larger and begins to move outboard across the main mirror as the vehicle approaches (A). The image transitions from the main mirror and begins to appear in the blind spot mirror as the vehicle approaches (B). The vehicle transitions to your peripheral field of view as it leaves the blind spot mirror (C).

You can adjust the interior mirror to your preference. Some mirrors also have a second pivot point. This lets you move the mirror head up or down and from side to side.

Note: Do not block the sensors on the front and back of the mirror. Mirror performance may be affected. A rear center passenger or raised rear center head restraint may also block light from reaching the sensor.
The mirror will dim automatically to reduce glare when bright lights are detected from behind your vehicle. It will automatically return to normal reflection when you select reverse gear to make sure you have a clear view when backing up.

The moonroof and sunshade controls are on the overhead console and have a one-touch open and close feature. There is only one control in the center position if the vehicle has a fixed glass roof. To stop it during one-touch operation, press the control a second time.

Opening the Sunshade and Moonroof
Press and release the control to open the sunshade. The front and rear sunshades open simultaneously.
Press and release the control to open the moonroof. The moonroof stops short of the fully opened position.

Closing the Moonroof and Sunshades
Pull and release the control. The moonroof stops short of the fully closed position. Pull the control again and hold to fully close the moonroof.
Pull and release the control to close the sunshades. The sunshades stop short of the fully closed position. Pull the control again and hold to fully close the sunshades.

WARNING LAMPS AND INDICATORS
The following warning lamps and indicators alert you to a vehicle condition that may become serious.  Some lamps illuminate when you start your vehicle to make sure they work.  If any lamps remain on after starting your vehicle, refer to the respective system warning lamp for further information.
Note: Some warning indicators appear in the information display and operate the same as a warning lamp but do not illuminate when you start your vehicle.

Service Engine Soon
If it illuminates when the engine is running this indicates a malfunction.  The On Board 
Diagnostics system has detected a malfunction of the vehicle emission control system.
If it flashes, engine misfire may be occurring. Increased exhaust gas temperatures could damage the catalytic converter or other vehicle components.  Drive in a moderate fashion (avoid heavy acceleration and deceleration) and have your vehicle immediately serviced.
It illuminates when you switch the ignition on prior to engine start to check the bulb and to indicate whether your vehicle is ready for Inspection and Maintenance (I/M) testing.

AUDIBLE WARNINGS AND INDICATORS
Keyless Warning Alert
The horn will sound twice when you exit your vehicle with the intelligent access key and your vehicle is in RUN, indicating your vehicle is still on.
Headlamps On Warning Chime
Sounds when you remove the key from the ignition and open the driver's door and you have left the headlamps or parking lamps on.
Parking Brake On Warning Chime
Sounds when you have left the parking brake on and drive your vehicle. If the warning chime remains on after you have released the parking brake, have the system checked by your authorized dealer immediately.

Switching the System Off and On
You can temporarily switch the Blind Spot Information System off in the information display.  See General Information (page 109). When the Blind Spot Information System switches off, you will not receive alerts and the information display shows a system off message. The telltale in the cluster also illuminates. When you switch the Blind Spot Information System on or off, the alert indicators flash twice.
Note: The system switches back on every time you start your vehicle.
You can also have the Blind Spot Information System switched off permanently at an authorized dealer. Once switched off permanently, the system can only be switched back on at an authorized dealer.

Free Pdf Lincoln MKT Owners Manual

Download Lincoln MKT Owners Manual


Related Manuals

Popular Manuals