Pdf Manual Guidelib.com

HAIMA 7 Service Manual(MT)-R Suspension system

HAIMA 7 Service Manual(MT)-R Suspension system

Online Pdf HAIMA 7 Service Manual(MT)-R Suspension system

General procedures  
Precautions to the suspension system  Removal/installation of wheels and tires  
1.  The tightening torque in the installation of wheels: 88-127N.m {9.0-13.0kgf.m, 65-94ft.lbf}.
Tightening of suspension system 
1. All parts with the rubber bushings in the suspension can be tightened only when the vehicle has been laid down and is free of load. 
No-load: fuel tank already filled up, engine coolant and lubricant already reached to the specified liquid level, spare tire jack and outfit placed at a specified locations. 
Connection or Cut-off of braking line 
Attention: The brake fluid is likely to damage the painted surface. If the brake fluid already got in touch with the painted surfaces, it should be immediately wiped up. 
1. Tighten the brake cone nut by use of the SST, confirm the tightening torque of adjusting brake cone nut to ensure the combination use of torque wrench and SST. 
2. Add the brake fluid, exhaust residual gas from the brake system if any of the braking lines is disconnected in the process and check if there is any leakage after the completion of operation. 
Removal/installation of power steering component
1.If any of the power steering oil lines is disconnected in the process, you should add ATF M-Ⅲ or Dexron II, exhaust residual oil from the oil lines and check if there is any leakage after the completion of operation.

Preliminary inspection of wheel alignment  
1. Check the tires inflation and adjust them to the recommended pressure 210kPa as required. 
2. Check the front bearing clearance and make the necessary correction as needed (Refer to M Check of Wheel Bearing Clearance). 
3. Check the radial run-outs of wheels and tires. 
4. Check whether there is any excessive looseness of the ball pin and steering linkages. 
5. Sway the bodywork to check the operation of shock absorber. 
Note: The vehicle must be of no-load and positioned on a level ground.  
No-load: fuel tank already filled up, engine coolant and lubricant already reached to the specified liquid level, spare tire jack and outfit placed at a specified locations. 
6.Measure the vertical height between the wheel center and fender edge, the difference in the measured values between the left and right sides cannot exceed 10 mm{0.39 in}. 

Managing the Vehicle Damage Repair Process
In the event that your vehicle requires damage repairs, GM recommends that you take an active role in its repair. If you have a pre-determined repair facility of choice, take your vehicle there, or have it towed there. Specify to the facility that any required replacement collision parts be original equipment parts, either new Genuine GM parts or recycled original GM parts. Remember, recycled parts will not be covered by your GM vehicle warranty.

Insurance pays the bill for the repair, but you must live with the repair. Depending on your policy limits, your insurance company may initially value the repair using aftermarket parts. Discuss this with your repair professional, and insist on Genuine GM parts. Remember if your vehicle is leased you may be obligated to have the vehicle repaired with Genuine GM parts, even if your insurance coverage does not pay the full cost.

If another party’s insurance company is paying for the repairs, you are not obligated to accept a repair valuation based on that insurance company’s collision policy repair limits, as you have no contractual limits with that company. In such cases, you can have control of the repair and parts choices as long as cost stays within reasonable limits.

Share:

Related Haima User Manuals

Popular User Manual (Show All)