HAIMA 7 Service Manual(MT)-H Clutch

Online Pdf HAIMA 7 Service Manual(MT)-H Clutch

Clutch Pedal Separation Point 
1.Engage parking brake and stick the front and rear wheels with wooden blocks. 
2.Start engine and run in idle. 
3.Do no step on the clutch pedal; slowly pull the shift lever to reverse gear 
4.When gear noise is heard, keep the shift lever in the very position.   
5.Step on the clutch pedal slowly. 
6.When the gear noise disappears, maintain the clutch pedal height (clutch pedal Separation Point). 
7.Measure the clutch pedal separation travel and total travel. 
8.Confirm they are within the specified range. 
If they are out of range, adjust pedal height or free travel to the specified values.  
Clutch pedal separation travel: 23-25mm (0.91—0.99in) (for reference) 

General Steps Clutch Pipe Removal/Installation
1.If the clutch has been disassembled for any purpose, please replenish brake fluid and bleed air in it; check for oil leakage after reinstallation. 
2.Remove the clutch pipe with SST (49 0259 770B) double open-end wrench, and install with torque rod and the tools mentioned above. 
3.Clutch flange nuts should be tightened to the required torque (see the General Steps 
- Torque Specifications) 

Online Pdf HAIMA 7 Service Manual(MT)-H Clutch