BATTERY CHARGE STATUS
The green bars show how much charge is left. Have the battery changed or recharged if the yellow light is ﬂashing.
Displays truck information such as: hours of operation, event codes along with instructions, battery charge and other data.
BATTERY RETAINER LIGHT (OPTION)
A red light will come on if the battery retainer is not properly installed.
(BATTERY GATE OPEN displayed)
SEAT BELT LIGHT (OPTION)
A red light will come on if you do not have your seat
SERVICE & OPTION BUTTONS
See Service Manual for instructions.
Indicates the level that your company has programmed this truck to operate at.
EVENT LIGHT (OPERATOR CORRECTABLE)
A yellow light will come on when there is a detected event which the operator can correct. See the message display for instructions.
SERVICE LIGHT (SERVICE REQUIRED)
A yellow light will come on when there is a detected event which requires service. Contact your supervisor or service department.
Managing the Vehicle Damage Repair Process
In the event that your vehicle requires damage repairs, GM recommends that you take an active role in its repair. If you have a pre-determined repair facility of choice, take your vehicle there, or have it towed there. Specify to the facility that any required replacement collision parts be original equipment parts, either new Genuine GM parts or recycled original GM parts. Remember, recycled parts will not be covered by your GM vehicle warranty.
Insurance pays the bill for the repair, but you must live with the repair. Depending on your policy limits, your insurance company may initially value the repair using aftermarket parts. Discuss this with your repair professional, and insist on Genuine GM parts. Remember if your vehicle is leased you may be obligated to have the vehicle repaired with Genuine GM parts, even if your insurance coverage does not pay the full cost.
If another party’s insurance company is paying for the repairs, you are not obligated to accept a repair valuation based on that insurance company’s collision policy repair limits, as you have no contractual limits with that company. In such cases, you can have control of the repair and parts choices as long as cost stays within reasonable limits.
This option provides ﬁngertip control of hydraulic functions, forward/reverse and horn. These controls replace the standard truck controls.
Press the button on the side to adjust the armrest forward or backward. Make certain the armrest locks into place when the desired position is located.
TRAVEL DIRECTION AND SPEED
Move the direction control away from you, toward the mast, to travel forks ﬁrst. Move the control toward you, away from the mast, to travel power unit ﬁrst (forks trailing).
Use the accelerator on the ﬂoor to control travel speed. The farther you push it down, the faster the truck will go.
If the truck will not move, check the message display.